Brake System Specifications

Front Brakes:
Caliper Bore Diameter 60.0 mm ( 2.36 inch)
Discard Thickness (see note) 24.7 mm (0.97 inch)
Minimum Rotor Thickness 25.0 mm (0.98 inch)
Rotor Thickness (new) 26.2 mm (1.03 inch)
Master Cylinder Bore 25.4 mm (1.000 inch)
Maximum Lateral Runout 0.06 mm (0.002 inch)
Maximum Scoring 1.50 mm (0.059 inch)
Rotor Diameter 278.0 mm (10.94 inch)
Thickness Variation 0.013 mm (0.0005 inch)
Rear Brakes:
Caliper Bore Diameter 38.0 mm (1.50 inch)
Discard Thickness (see note) 9.0 mm (0.35 inch)
Minimum Wear Thickness 10.6 mm (0.41 inch)
Rotor Thickness (new) 11.0 mm (0.43 inch)

Note: All brake rotors have a discard dimension cast into them. Replace any rotor that does not meet this specification. After refinishing the rotor, replace any rotor that does not meet the maximum or minimum thickness after refinish specifications.