Engine Flywheel Replacement

Removal Procedure

^ Tools Required
- J 37096 Flywheel Holding Tool





1. Remove the clutch pressure plate and driven disc.
2. Use the J 37096 to hold the flywheel to loosen the flywheel bolts.





3. If equipped with the manual transmission, remove the following components:
3.1. Remove the flywheel bolts (1).
3.2. Remove the flywheel (2).

Installation Procedure

^ Tools Required
- J 36660-A Torque Angle Meter
- J 37096 Flywheel Holding Tool





1. Install the following components:
1.1. Install the flywheel (2).
1.2. Install the flywheel bolts (1) finger tight.





2. Use the J 37096 to hold the flywheel when tightening the flywheel bolts.

Notice: Refer to Fastener Notice in Service Precautions.

3. Tighten the flywheel bolts.
^ Tighten the flywheel bolts to 15 Nm (11 ft. lbs.). Use the J 36660-A to torque the flywheel bolts an additional 50 degrees.
4. Install the clutch pressure plate and driven disc.