Crankshaft Position (CKP) Sensor Replacement (7X)

REMOVAL PROCEDURE
1. Remove the negative battery cable.
2. Turn the steering wheel fully to the left.
3. Raise vehicle on hoist. Refer to Lifting and Jacking the Vehicle in General information.
3. Disconnect the electrical connector.
5. Remove the retaining bolt.
6. Remove the sensor from the engine.
7. If the sensor is not being replaced inspect for the following:
7.1. Inspect the sensor for wear, cracks, or leakage. Replace the O-ring if necessary.
7.2. Lubricate the new O-ring with clean engine oil before installing.

INSTALLATION PROCEDURE
1. Install the sensor into the block.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Reinstall the retainer bolt to hold sensor to block face.

Tighten
Tighten the bolt to 8 N.m (71 lb in).

3. Connect the electrical connector.
4. Lower the vehicle.
5. Reconnect the negative battery cable.