RH
REMOVAL PROCEDURECAUTION: Refer to SIR Inflator Module Handling And Storage Caution in Service Precautions.
1. Disable the SIR system.
2. Remove the passenger seat.
3. Remove the J-clip that is along the lower rear seat back.
4. Remove the seat back cover.
5. Remove the passenger side air bag fasteners (1).
6. Note the routing of the passenger side air bag wiring harness (3) and retaining clip attachments within the passenger seat.
7. Remove the passenger side air bag wiring harness retaining clips from the passenger seat frame.
8. Gently pull the passenger side air bag wiring harness (3) up into the seat back while guiding the harness through the wire triangle of the seat frame.
9. Remove the passenger side air bag (2) from the passenger seat back frame.
INSTALLATION PROCEDURE
1. Install the passenger side air bag (2) to the seat while guiding the passenger side air bag wiring harness (3) through the trip cup.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the passenger side air bag fasteners (1).
Tighten
Tighten the passenger side air bag fasteners (1) to 10 N.m (89 lb in).
3. Gently pull the passenger side air bag wiring harness (3) down into the seat cushion while guiding the harness through the wire triangle of the seat frame.
4. Install the harness retaining clips to the seat frame.
5. Install the seat back cover.
6. Connect together the J-clip that is along the lower rear seat back.
7. Install the passenger seat.
8. Enable the SIR system.