Ignition Lock: Service and Repair
IGNITION LOCK ACTUATORREMOVAL PROCEDURE
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.
Air Bag(s) Arming and Disarming
CAUTION: Refer to SIR Caution in Service Precautions.
SIR Caution
2. Remove the lock cylinder.
3. Remove the steering column tilt head housing.
4. Remove the 2 tapping screws (1).
5. Remove the lock bolt support bracket (2).
6. Remove the lock bolt assembly (3).
7. Remove the ignition lock actuator assembly (4).
INSTALLATION PROCEDURE
1. Install the ignition lock actuator assembly (4).
2. Install the lock bolt assembly (3).
3. Install the lock bolt support bracket (2).
4. Install the 2 tapping screws (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Fastener Notice
Tighten
Tighten the screws to 1.5 Nm (13 lb in).
5. Install the steering column tilt head housing.
6. Install the lock cylinder.
7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.