Operation CHARM: Car repair manuals for everyone.
Home >> Pontiac >> 2004 >> Aztek AWD V6-3.4L VIN E >> Repair and Diagnosis >> Brakes and Traction Control >> Antilock Brakes / Traction Control Systems >> Wheel Speed Sensor >> Service and Repair >> Wheel Speed Sensor Jumper Harness Replacement >> Front
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Front

Wheel Speed Sensor Jumper Harness Replacement - Front

Removal Procedure





1. Disconnect the front wheel speed sensor jumper harness to ABS harness connector (8).
2. Raise and support the vehicle on a suitable hoist.
3. Remove the harness (4) from the splash shield retaining clip (5).
4. Remove the harness (4) from the control arm retaining clips (3).





5. Disconnect the front wheel speed jumper harness connector (2) from the front wheel sensor.
6. Remove the front wheel speed sensor jumper harness (1).

Installation Procedure





1. Connect the front wheel speed sensor jumper harness connector (2) to the wheel speed sensor.





2. Install the harness (4) to control arm retaining clips (3).
3. Install the harness (4) to splash shield retaining clip (5).
4. Lower the vehicle.
5. Connect the front wheel speed sensor jumper harness to ABS harness connector (8).
6. Turn the ignition switch to the RUN position, with the engine off.
7. Perform the Diagnostic system check. Refer to Diagnostic System Check - ABS.
pro multis · About Operation CHARM