Wiper Motor Replacement - Rear
WIPER MOTOR REPLACEMENT - REARREMOVAL PROCEDURE
1. Remove the rear wiper arm.
2. Remove the seal from the wiper motor driveshaft.
3. Remove the liftgate access trim panel.
4. Remove the rear wiper motor screws.
5. Disconnect the rear wiper motor electrical connector.
6. Remove the rear wiper motor from the liftgate.
INSTALLATION PROCEDURE
1. Connect the rear wiper motor electrical connector.
2. Position the rear wiper motor to the liftgate.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the rear wiper motor screws.
Tighten
Tighten the screws to 6 N.m (53 lb in).
4. Install the liftgate access trim panel.
5. Install the seal onto the rear wiper motor driveshaft.
6. Install the rear wiper arm.