Rear Door Window Glass: Service and Repair

Window Replacement - Rear Door

Removal Procedure





1. Remove the rear door trim panel. Refer to Trim Panel Replacement - Rear Door (Removal and Replacement) in Interior Trim.
2. Remove the outside channel molding. Refer to Window Run Channel Replacement - Rear Door (Window Run Channel Replacement - Rear Door) in Doors.
3. Remove the interior rear door garnish molding.
4. Remove the screws and the exterior rear door garnish molding.




5. Remove the door seal trim. Refer to Water Deflector Replacement - Door (Service and Repair) in Doors.
6. Remove the screws that secure the glass to the window regulator.




7. Remove the bolts and the guide rail.
8. Remove the glass from the door.



Installation Procedure





1. Install the glass in the door.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the guide rail and the bolts.

Tighten the guide rail bolts to 7 N.m (62 lb in).





3. Position the glass within the window regulator.
4. Install the glass screws.

Tighten the door glass screws to 7 N.m (62 lb in).





5. Install the door seal trim. Refer to Water Deflector Replacement - Door (Service and Repair) in Doors.
6. Install the exterior rear door garnish molding with the screws.

Tighten the exterior rear door garnish molding screws to 1.5 N.m (13 lb in).

7. Install the interior rear door garnish molding.
8. Install the outside channel molding. Refer to Window Run Channel Replacement - Rear Door (Window Run Channel Replacement - Rear Door) in Doors.
9. Install the rear door trim panel. Refer to Trim Panel Replacement - Rear Door (Removal and Replacement) in Interior Trim.