Sail Panel Replacement

Sail Panel Replacement

Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

Removal Procedure




1. Pull the rear door weatherstrip from the pinchweld flange as required.
2. If the vehicle does not have a side curtain airbag, use J 38778 to disengage the retaining clips.
3. If the vehicle has a side curtain air bag perform the following procedure:

* Use a flat-bladed tool to remove the screw button cover.
* Remove the retaining screw.
* Use J 38778 to disengage the retaining clip.

4. Remove the trim panel from the vehicle.




5. If damaged, drill out the rivet on the retaining clip (2).
6. Remove the retaining clip from the vehicle.

Installation Procedure




1. If removed, position the retaining clip in the vehicle.
2. Install the rivet (1) on the retaining clip (2).




3. Position the panel on the rear quarter.
4. Install the locator tab at the rear of the panel.
5. Press in on the sail panel to secure the retaining clips.

Notice: Refer to Fastener Notice in Service Precautions.

6. If equipped, install the retaining screw.

Tighten the screw to 2 N.m (18 lb in).

7. Press in to secure the screw button cover.