Transfer Case Bracket Replacement

Transfer Case Bracket Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the right hand axle.




3. Disconnect the electrical connectors from the crankshaft position sensor (2) and the knock sensor (1).




4. Remove the bolts from the transfer case mounting bracket and engine.
5. Remove the bracket.

Installation Procedure





Notice: Refer to Fastener Notice.

1. Position the transfer case mounting bracket to the vehicle and hand start all bolts.

Tighten the bolts to 50 N.m (37 lb ft).




2. Connect the electrical connectors to the crankshaft position sensor (2) and the knock sensor (1).
3. Install the right hand axle.
4. Lower the vehicle.