Oil Cooler Line Replacement

Oil Cooler Line Replacement

Removal Procedure

Caution: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.

1. Position the vehicle on a hoist and raise the hood.
2. Place a drain pan or suitable container under the vehicle.




3. Disconnect the upper transaxle oil cooler line from the radiator.
4. Raise the vehicle. Refer to Vehicle Lifting.
5. Disconnect the lower transaxle oil cooler line.




6. Disengage the transaxle cooler lines from the fan shroud.




7. Remove the transaxle cooler line assembly nut (2) from the transaxle.
8. Remove the transaxle cooler lines (1) from the vehicle.
9. Replace the transaxle oil cooler pipe seals.

Installation Procedure




1. Install the transaxle oil cooler lines into the vehicle.
2. Install the transaxle oil cooler line assembly (1) to the transaxle.

Notice: Refer to Fastener Notice.

3. Install the transaxle oil cooler line assembly nut (2).

Tighten the transaxle oil cooler lines to 9 N.m (80 lb in).

4. Connect the lower transaxle oil cooler line to the radiator.




5. Engage the transaxle oil cooler lines with the fan shroud by snapping in place.
6. Lower the vehicle.




7. Connect the upper transaxle oil cooler line to the radiator.

Important: DEXRON(R) VI automatic transmission fluid is not compatible with this transaxle. If DEXRON(R) VI ATF is used, transaxle failure will result. This transaxle uses GM T-IV fluid P/N 88900925.

8. Add fluid to the transaxle. Refer to the Transmission Fluid Checking. Testing and Inspection
9. Start the engine a check for leaks.