Tail Lamp: Service and Repair

TAIL LAMP REPLACEMENT

REMOVAL PROCEDURE




1. Open the rear compartment lid.
2. Remove the rear compartment trim panel (4).
3. Disconnect the tail lamp electrical connectors.
4. Remove the following components from the vehicle:
- The 3 nuts (3)
- The tail lamp (7)
5. Remove the following from the tail lamp:
- The stop lamp socket (2)
- The turn signal lamp socket (5)
6. Remove the following from the lamp sockets, if necessary:
- The stop lamp bulb (1)
- The turn signal lamp bulb (6)

INSTALLATION PROCEDURE




1. Install the following to the lamp sockets, if removed:
- The stop lamp bulb (1)
- The turn signal lamp bulb (6)
2. Install the following to the tail lamp:
- The stop lamp socket (2)
- The turn signal lamp socket (5)

3. NOTE: Refer to Fastener Notice in Service Precautions.

Install the tail lamp (7) to the vehicle. Secure the tail lamp (7) with the 3 nuts (3).

Tighten the tail lamp nuts to 10 N.m (89 lb in).

4. Connect the tail lamp electrical connectors.
5. Install the rear compartment trim panel (4) to the vehicle.
6. Close the rear compartment lid.