Operation CHARM: Car repair manuals for everyone.
Home >> Pontiac >> 2008 >> G6 L4-2.4L >> Repair and Diagnosis >> Accessories and Optional Equipment >> Pedal Positioning System >> Service and Repair >> Brake Pedal Assembly Replacement
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Brake Pedal Assembly Replacement



Brake Pedal Assembly Replacement

Removal Procedure

1. Remove the knee bolster.
2. Remove the closeout panel.
3. Remove the electrical connector from the brake apply sensor.
4. Remove the electrical connector from the brake pedal adjustment position sensor.
5. Remove the steering column assembly from the vehicle.
6. Remove the cable from the adjustable pedal assemblies.




7. Remove the 2 brake pedal assembly to cowl mounting nuts.




8. Remove the booster pushrod retaining clip (1), the washers (2), and the booster pushrod (3) from the adjustable pedal pivot pin (4).




9. Remove the 3 brake pedal assembly to instrument panel (I/P) carrier bolts.
10. Remove the adjustable brake pedal assembly from the vehicle.

Installation Procedure

Important: Ensure that the adjustable brake pedal and adjustable accelerator pedal are synchronized in the full rearward position.

1. Insert a #4 square drive tool into the adjustable brake pedal actuator assembly and turn until the adjustable brake pedal assembly moves fully rearward.




2. Install the adjustable brake pedal assembly to the vehicle.

Notice: Refer to Fastener Notice.

3. Install the 3 brake pedal assembly to I/P carrier bolts.

Tighten the bolts to 25 N.m (18 lb ft).




4. Install the 2 brake pedal assembly to cowl mounting nuts.

Tighten the nuts to 15 N.m (11 lb ft).




5. Install the booster pushrod retaining clip (1), the washers (2), and the booster pushrod (3) to the adjustable pedal pivot pin (4).
6. Install the steering column assembly to the vehicle.
7. Install the NEW cable.
8. Install the electrical connector to the brake pedal adjustment position sensor.
9. Install the electrical connector to the brake apply sensor.
10. Install the closeout panel.
11. Install the knee bolster.
12. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration.
pro multis · About Operation CHARM