Operation CHARM: Car repair manuals for everyone.
Home >> Pontiac >> 2008 >> G6 L4-2.4L >> Repair and Diagnosis >> Brakes and Traction Control >> Brake Pedal Assy >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Brake Pedal Assy: Service and Repair



Brake Pedal Assembly Replacement

Removal Procedure

1. Remove the knee bolster. Refer to Knee Bolster Replacement .
2. Remove the closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
3. Remove the electrical connector from the brake apply sensor.
4. Remove the steering column assembly from the vehicle. Refer to Steering Column Replacement (Electronic Power Steering) Steering Column Replacement (Hydraulic Power Steering) .




5. Disconnect the brake pedal pushrod retaining clip (1) the wave washers (2) and the brake booster pushrod (3) from the brake pedal pin (4).




6. Remove the 2 brake pedal assembly to cowl mounting nuts.




7. Remove the 3 brake pedal assembly to instrument panel (I/P) carrier bolts.
8. Remove the brake pedal assembly from the vehicle.



Installation Procedure





1. Install the brake pedal assembly to the vehicle.

Notice: Refer to Fastener Notice .

2. Install the 3 brake pedal assembly to I/P carrier bolts.

Tighten the bolts to 25 N.m (18 lb ft).





3. Install the 2 brake pedal assembly to cowl mounting nuts.

Tighten the nuts to 15 N.m (11 lb ft).





4. Connect the brake pedal pushrod retaining clip (1) the wave washers (2) and the brake booster pushrod (3) to the brake pedal pin (4).
5. Install the steering column assembly to the vehicle. Refer to Steering Column Replacement (Electronic Power Steering) Steering Column Replacement (Hydraulic Power Steering) .
6. Install the electrical connector to the brake apply sensor.
7. Install the closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
8. Install the knee bolster. Refer to Knee Bolster Replacement .
9. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .


pro multis · About Operation CHARM