Oil Pressure Sensor: Service and Repair

Engine Oil Pressure Sensor and/or Switch Replacement

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the oil pressure heat shield bolts and shield.




3. Disconnect engine oil pressure sensor electrical connector (1).




4. Remove the engine oil pressure sensor.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the engine oil pressure sensor.

Tighten the sensor to 16 Nm (12 lb ft).




2. Connect engine oil pressure sensor electrical connector (1).




3. Install the oil pressure heat shield and bolts.

Tighten the bolts to 10 Nm (89 lb in).

4. Lower the vehicle.