With Mark II ABS System

Front brake calipers must be bled first.
1. Fill fluid reservoir to the top.
2. Connect a length of transparent hose to right front caliper bleed nipple and place other end of hose into a clear container.
3. While depressing brake pedal, open bleed nipple.
4. Repeat step 3 until there are no more air bubbles visable in the hose.
5. Connect hose to left front caliper and repeat steps 3 and 4.
6. Connect hose to either rear caliper, switch on ignition and repeat steps 3 and 4. Pump motor must not run for more than two minutes at a time. After motor has been running, let it cool for approximately 10 minutes.
7. Repeat step 6 on the other rear caliper, then fill fluid reservoir.