P0107

Diagnostic Chart:

Wiring Diagram:

Description:

The manifold absolute pressure (MAP) sensor is a variable resistor that responds to changes in manifold pressure (vacuum). The PCM measures the voltage drop across the MAP sensor. The voltage ranges from 1-1.5 volts at idle (high vacuum) to 4-4.5 volts at wide-open throttle (low vacuum).

DTC PARAMETERS
DTC P0107 will set if MAP is less than 0.30 volts when either:
1. Engine speed is less than 1000 rpm, and
2. No TP sensor DTCs have been set
or
1. Engine speed is greater than 1000 rpm, and
2. TP sensor is greater than 10 percent, and
3. No TP sensor DTCs have been set.

IMPORTANT: MAP signal is continuously checked when engine is running.

DIAGNOSTIC AIDS
With the engine Off and key On the map reading should be the same as the barometric reading because manifold pressure is equal to atmospheric pressure (no vacuum - high voltage). Comparing this reading to a known good vehicle with the same sensor is a good way to check accuracy of a suspect sensor. Readings should be within 0.4 volts.