Intake Manifold

Intake Manifold Coolant Pipe Bolt 10 Nm (89 inch lbs.)
Knock Sensor 25 Nm (18 ft. lbs.)





Notice: Maximum gasket performance is achieved when using new fasteners, which contain a thread-locking patch. If the fasteners are not replaced, a thread locking chemical must be applied to the fastener threads. Failure to replace the fasteners or apply a thread-locking chemical MAY reduce gasket sealing capability.

Lower Intake Manifold Bolt - Center
^ First Pass 13 Nm (115 inch lbs.)
^ Final Pass 20 Nm (15 ft. lbs.)
Lower Intake Manifold Bolt - Corner
^ First Pass 13 Nm (115 inch lbs.)
^ Final Pass 25 Nm (18 ft. lbs.)
Throttle Body Bolt 10 Nm (89 inch lbs.)
Throttle Body Stud 6 Nm (53 inch lbs.)
Upper Intake Manifold Bolt/Stud 25 Nm (18 ft. lbs.)