Operation CHARM: Car repair manuals for everyone.
Home >> Scion >> 2012 >> tC L4-2.5L (2AR-FE) >> Repair and Diagnosis >> Heating and Air Conditioning >> Condenser HVAC >> Service and Repair >> Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Installation





HEATING / AIR CONDITIONING: CONDENSER: INSTALLATION

1. INSTALL COOLER DRYER

(a) Using pliers, install the cooler dryer.

(b) Apply a sufficient amount of compressor oil to the contact surfaces of a new O-ring and the cap.

Compressor oil:

ND-OIL 8 or equivalent





(c) Install the O-ring to the cap.

(d) Using a 14 mm socket hexagon wrench, install the cap to the modulator.

Torque : 2.9 Nm (30 kgf-cm, 26 in-lbf)

2. INSTALL COOLER CONDENSER ASSEMBLY

(a) Install the cooler condenser assembly.

HINT
If the condenser is replaced with a new one, add compressor oil to the new condenser.

Compressor oil:

ND-8 or equivalent

(b) Install the No. 2 fan shroud with 2 bolts.

Torque : 7.0 Nm (71 kgf-cm, 52 in-lbf)

3. INSTALL UPPER RADIATOR SUPPORT Installation

4. INSTALL BATTERY CLAMP SUB-ASSEMBLY Installation

5. INSTALL HIGH PITCHED HORN ASSEMBLY Installation

6. INSTALL LOW PITCHED HORN ASSEMBLY Installation

7. INSTALL HOOD LOCK ASSEMBLY Installation

8. INSTALL AIR CONDITIONING TUBE ASSEMBLY

(a) Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser.

(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the tube joint.

Compressor oil:

ND-OIL 8 or equivalent

(c) Install the O-ring to the air conditioning tube assembly.

(d) Install the air conditioning tube assembly to the cooler condenser with the 2 bolts.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

9. INSTALL NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

(a) Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser.

(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the hose joint.

Compressor oil:

ND-OIL 8 or equivalent

(c) Install the O-ring to the No. 1 cooler refrigerant discharge hose.

(d) Install the No. 1 cooler refrigerant discharge hose to the cooler condenser with the bolt.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

10. ADJUST HOOD SUB-ASSEMBLY Adjustments

11. INSTALL FRONT BUMPER COVER

Installation

12. CHARGE REFRIGERANT Service and Repair

13. WARM UP ENGINE Service and Repair

14. CHECK FOR REFRIGERANT LEAK Service and Repair
pro multis · About Operation CHARM