Installation
2AR-FE ENGINE CONTROL: CRANKSHAFT POSITION SENSOR: INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR
(a) Apply a light coat of engine oil to the O-ring of the sensor.
NOTICE:
Make sure that the O-ring is not cracked or jammed when installing the sensor.
(b) Clean the bolt and bolt hole.
(c) Apply adhesive to 2 or 3 threads of the bolt.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.
(d) Install the sensor with the bolt.
Torque : 6.5 Nm (66 kgf-cm, 58 in-lbf)
(e) Connect the sensor connector.
2. INSPECT FOR OIL LEAK Replacement
3. INSTALL REAR ENGINE UNDER COVER RH Installation