Toe-In

Fig. 4 Front toe-in adjustment:

Ensure tires are properly inflated prior to checking or adjusting toe.

FRONT

The following procedure may be used to correct toe-in, if out of specifications.
1. Loosen both left and right tie rod locknuts, Fig. 4.
2. Turn both tie rods an equal amount until toe-in is within specifications.

Fig. 5 Cam bolt location. Justy:

REAR

1. Release parking brake lever.
2. Loosen cam bolt locknut approximately 1/2 turn, Fig. 5.
3. Turn cam bolt in opposite direction of that required to eliminate free play, then turn cam bolt as required and adjust toe setting. Each scale mark on cam represents a .12 inch change in toe setting.
4. After adjustment is completed, tighten locknut.