Fuel Delivery and Air Induction: Service and Repair

1) Release fuel pressure.
2) Remove fuel filler cap.





3) Disconnect battery ground cable.





4) Remove access hole lid.





5) Disconnect connector from fuel pump.
6) Disconnect quick connector, and then disconnect fuel delivery hose (A).





7) Move clips, and then disconnect fuel return hose (B) and jet pump hose (C).





8) Remove nuts which install fuel pump assembly onto fuel tank.





9) Take off fuel pump from fuel tank.





10) Drain fuel from fuel tank by using a hand pump.

WARNING: Do not use a motor pump when draining fuel.





11) Remove fuel sub meter unit.





12) Drain fuel from there.

WARNING: Do not use a motor pump when draining fuel.

13) After draining fuel, reinstall fuel pump and fuel sub meter unit.








Tighten nuts of fuel pump in numerical sequence shown in figure to specified torque.

Tightening torque: 4.4 ± 1.5 Nm (0.45 ± 0.15 kg/cm2, 3.3 ± 1.1 ft. lbs.)