Rear Door Window Glass: Service and Repair

REMOVAL

1. Disconnect connector from rear defogger terminal.
2. Remove glass in the same manner as in windshield.






NOTE: A matching pin is cemented to the corners of glass on compartment side. Use a piano wire when cutting each pin.

INSTALLATION




1. Install glass in the same manner as in windshield.
2. Stick dam rubber (1).
3. While aligning ceramic print notch (2) on rear window glass with marks in the center of upper and lower moldings, install the two moldings on rear window glass.
4. Make rear defogger connections.
5. After installation, test for water leakage after about one hour, and leave vehicle alone for 24 hours.