Transmission Position Sensor/Switch: Service and Repair
AT Shift Lock Solenoid and P Range SwitchREMOVAL
NOTE: For removal of the mode change switch and the shift button switch, refer to the section on Select Levers.
1. P RANGE SWITCH
1. Remove the console box.
2. Disconnect the connector.
3. Remove the connector from the base plate using a flat-tip screwdriver.
4. Disconnect the terminal of P range switch from connector, using a flat-tip screwdriver with thin tip.
5. Remove the clip while being careful not to break the pin, then remove the P range switch.
2. AT SHIFT LOCK SOLENOID
1. Remove the console box.
2. Disconnect the connector.
3. Remove the connector from the base plate using a flat-tip screwdriver.
4. Remove the AT shift lock solenoid.
5. Disconnect the terminal of AT shift lock solenoid from the connector, using a flat-tip screwdriver.
INSTALLATION
NOTE: For installation of the mode change switch and the shift button switch, refer to the section on Select Levers.
1. P RANGE SWITCH
Install in the reverse order of removal.
NOTE: Connect the P range switch terminal to connector.
2. AT SHIFT LOCK SOLENOID
Install in the reverse order of removal.
NOTE: Connect the AT shift lock solenoid switch terminal to connector.
INSPECTION
