Preparation For Overhaul Procedure
Preparation for OverhaulPROCEDURE
1) Clean oil, grease, dirt and dust from transmission.
2) Remove the drain plug using TORX BIT T70, and drain the oil completely. After draining, retighten it.
NOTE:
Replace the gasket with a new one.
3) Attach the transmission to ST.
ST 499937100 TRANSMISSION STAND
4) Rotating parts should be coated with oil prior to assembly.
5) All disassembled parts, if to be reused, should be reinstalled in the original positions and directions.
6) Gaskets, lock washers and lock nut must be replaced with new ones.
7) Liquid gasket should be used where specified to prevent leakage.