Disassembly and Assembly

WIPER BLADE

DISASSEMBLY

1. METAL TYPE

Pull on the side (A) of wiper rubber stopper, and then remove the rubber from blade assembly.

2. RESIN TYPE

Pull the wiper rubber top slightly from the stopper (A) and pull it out fully.

ASSEMBLY

1. METAL TYPE

1. Insert the wiper rubber onto blade so that the stopper is in the position shown.

2. Make sure the wiper rubber is securely fastened to the pull stopper (A).

2. RESIN TYPE

1. Insert the wiper rubber through the claw (B).

2. Insert the wiper rubber top until it protrudes about 20 mm (0.79 in) from the stopper (D).

3. Insert the wiper rubber into the claw (A).