Wiper Motor Linkage: Service and Repair

FRONT WIPER MOTOR AND LINK

REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the cowl panel.
3. Disconnect the connector of motor.




4. Remove the bolts to remove wiper link.




5. Remove the bolts and nuts to remove motor.

INSTALLATION
1. Connect the battery ground cable to battery.
2. To confirm that the motor is at auto stop position, connect the harness to motor and turn the wiper switch ON/OFF once.
3. Disconnect the ground cable from battery.




4. Tighten the nut where rod (A) and link plate (B) is aligned in a straight line.
5. Install in the reverse order of removal.

Tightening torque: Nm (kgf-m, ft-lb)
T1: 6.0 (0.61, 4.4)
T2: 20 (2.0, 14.5)