Manual Transmission
Installation1. Installation of neutral position switch
(1) Install a new gasket to the neutral position switch.
(2) Install the neutral position switch.
Standard value:T=32.3Nm {329.4kgf-cm} {23.8ft-lbf}
CAUTION:
When tightening by combining a torque wrench and union nut wrench to extend the whole length, the actual torque will be excessive if tightened until the reading of the torque wrench reaches the specified tightening torque.
(3) Engage all of the 3 clamps from the rear side with a slack of the harness positioned at the forward end, and connect the back-up light switch ASSY wire and the neutral position switch wire.
2. Installation of manual transmission ASSY