Installation

Switches and Harness

INSTALLATION

BACK-UP LIGHT AND NEUTRAL POSITION SWITCH

1) Install the back-up light switch & neutral position switch with the harness.

NOTE:
Use a new gasket.

Tightening torque:
32.3 Nm (3.3 kgf-m, 23.8 ft-lb)





2) Secure the switch harness on each clip.
3) Lower the vehicle.
4) Connect the connectors for back-up light switch and neutral position switch, and secure the connector to the bracket.
5) Install the air intake boot.
6) Connect the battery ground terminal.