Installation

INSTALLATION

CAUTION:
^ Be sure to use a new self-locking nut.
^ Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.

1) Check the removed parts for wear, damage and crack, and repair or replace them if faulty.
2) Install each part in the reverse order of removal.

Tightening torque:
Refer to "COMPONENT" of "General Description" for the tightening torque. Rear Suspension

3) Bleed air from brake system.
4) Install the rear wheels.

Tightening torque:
120 Nm (12.24 kgf-m, 88.5 ft-lb)

5) Inspect the wheel alignment and adjust if necessary. Service and Repair

CAUTION:
When the wheel alignment has been adjusted, perform the 0 point setting mode for each sensor in the VDCCM&H/U.