Pinout Values and Diagnostic Parameters

NOTE: ECM and its circuits can be checked at ECM wiring couplers by measuring voltage and resistance.

CAUTION: ECM cannot be checked by itself. It is strictly prohibited to connect voltmeter or ohmmeter to ECM with coupler disconnected from it.

Part 1 Of 3:

VOLTAGE CHECK
1. Remove ECM from body.
2. Check voltage at each terminal of couplers connected.

NOTE: As each terminal voltage is affected by the battery voltage, confirm that it is 11V or more when ignition switch is ON.

Part 2 Of 3:

Part 3 Of 3:

RESISTANCE CHECK
1. Disconnect ECM couplers from ECM with ignition switch OFF.

CAUTION: Never touch terminals of ECM itself or connect voltmeter or ohmmeter.

2. Check resistance between each terminal of couplers disconnected.

CAUTION:
- Be sure to connect ohmmeter probe from wire harness side of coupler.
- Be sure to turn OFF ignition switch for this check.
- Resistance in table below represents that when parts temperature is 20°C (68°F).