Quarter Window Glass: Service and Repair

QUARTER WINDOW REMOVAL AND INSTALLATION




Refer to Head lining Removal and Installation, Windshield Removal and Installation procedures and cautions are basically the same. However, note the following.

NOTE:
- Before applying primer (5) to glass edge, install molding (3) according to installing position shown in the figure.
- Observe the following precautions when applying adhesive (4) along glass edge.
- Adhesive should be applied evenly especially in height.
- Be careful not to damage primer.
- Press glass (2) against body quickly after adhesive is applied.

Adhesive amount specifications (quarter window)
Height "a": 12 mm (0.47 in.)
Width "b": 8 mm (0.31 in.)
Width "c": 16 mm (0.63 in.) for glass front, rear and upper section.
Width "c": 14 mm (0.55 in.) for glass bottom section.
Position "e": 177 mm (6.97 in.) for left side glass front section.
Position "e": 75 mm (2.95 in.) for right side glass front section.
Position "d": 29 mm (1.15 in.) for glass rear section.
Position "d": 39 mm (1.54 in.) for glass upper section.
Position "d": 22 mm (0.87 in.) for glass bottom section.