Removal and Installation

Airbag Sensor Assembly:

REMOVAL

NOTE:
Do not open the cover or the case of the ECU and various electrical devices unless absolutely necessary.
(If the IC terminals are touched, the IC may be destroyed by static electricity.)

1. REMOVE LOWER FINISH PANEL
2. REMOVE LOWER NO.1 PANEL
3. REMOVE FINISH PANEL
4. REMOVE UPPER CONSOLE COVER
5. REMOVE CONSOLE BOX HOLE COVER
6. REMOVE CONSOLE BOX
7. REMOVE END FINISH PANEL LH
8. REMOVE END FINISH PANEL RH




9. REMOVE AIRBAG SENSOR ASSEMBLY
a. Disconnect the airbag sensor connectors.

NOTE: Disconnect the connectors with the airbag sensor assembly installed.

b. Using a torx wrench, remove the 3 screws and airbag sensor assembly.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)

INSTALLATION

NOTE:
- Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
- Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
- Never repair a sensor in order to reuse it.




1. INSTALL AIRBAG SENSOR ASSEMBLY
a. Using a torx wrench, install the airbag sensor assembly with the 3 screws.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)

Torque: 20 N.m (205 kgf.cm, 15 ft.lbf)

b. Connect the airbag sensor connectors.

NOTE:
- Connection of the connector is done after the sensor assembly has been installed.
- Make sure the sensor assembly is installed with the specified torque.
- If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
- When installing the senor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- After installing, shake the sensor assembly to check that there is no looseness.

2. INSTALL END FINISH PANEL RH
3. INSTALL END FINISH PANEL LH
4. INSTALL CONSOLE BOX
5. INSTALL CONSOLE BOX HOLE COVER
6. INSTALL UPPER CONSOLE COVER
7. INSTALL FINISH PANEL
8. INSTALL LOWER NO.1 PANEL
9. INSTALL LOWER FINISH PANEL