Crankshaft Position Sensor: Service and Repair

Crankshaft Position Sensor:

REMOVAL
1. REMOVE INTAKE MANIFOLD
2. REMOVE ENGINE UNDER COVER RH

3. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the crankshaft position sensor connector.

b. Remove the 2 bolt and crankshaft position sensor.

Torque: 8.8 N.m (90 kgf.cm, 78 in.lbf)

INSPECTION

NOTE: "Cold" and "Hot" in these sentences express the temperature of the sensor itself. "Cold" is from -10 °C (14 °F) to 50 °C (122 °F) and "Hot" is from 50 °C (122 °F) to 100 °C (212 °F).

INSPECT CRANKSHAFT POSITION SENSOR RESISTANCE
Using an ohmmeter, measure the resistance between terminals.

Resistance:
Cold: 1,630 - 2,740 Ohm
Hot: 2,065 - 3,225 Ohm

If the resistance is not as specified, replace the crankshaft position sensor.

INSTALLATION
Installation is in the reverse order of removal