Rear Wiper and Washer
REMOVAL1. w/ Rear spoiler:
REMOVE REAR SPOILER
2. REMOVE DOOR PULL HANDLE
3. REMOVE BACK DOOR TRIM BOARD
Using a screwdriver, remove the back door trim board.
HINT: Tape the screwdriver tip before use.
4. REMOVE REAR WIPER ARM
5. REMOVE REAR WIPER MOTOR
a. Disconnect the connector.
b. Unfasten the 3 bolts and remove the rear wiper motor.
c. Remove the packing.
6. REMOVE REAR WASHER NOZZLE
a. Remove the 2 nuts.
b. Disconnect the connector and washer hose, then remove the center stop light in order A, B as shown in the illustration.
c. Remove the screw and rear washer nozzle from the center stop light.
INSTALLATION
1. INSTALL REAR WASHER NOZZLE
a. Install the rear wiper nozzle to the center step light with the screw.
b. Connect the connector and washer hose, then install the center stop light with the 2 nuts in order A, B as shown in the illustration.
c. Connect the connector and washer hose, then install the center stop light with the 2 nuts.
2. INSTALL REAR WIPER MOTOR
a. Install the packing.
b. Install the rear wiper motor and fasten the 3 bolts.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
c. Connect the connector.
3. INSTALL BACK DOOR TRIM BOARD
4. INSTALL DOOR PULL HANDLE
5. INSTALL REAR WIPER ARM
a. Operate the wiper motor once and turn the wiper switch OFF.
b. Install the rear wiper arm and tighten the nut by hand.
c. Adjust the installation position of the wiper arm at a point in defogger pattern.
d. Tighten the nut.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
6. w/ Rear spoiler:
REMOVE REAR SPOILER