Operation CHARM: Car repair manuals for everyone.
Home >> Toyota >> 2003 >> Tundra 2WD V6-3.4L (5VZ-FE) >> Repair and Diagnosis >> Heating and Air Conditioning >> Control Assembly >> Service and Repair >> Heater Control Assembly >> Disassembly and Reassembly
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Disassembly and Reassembly

HEATER CONTROL ASSEMBLY

DISASSEMBLY




1. REMOVE HEATER CONTROL CABLES
a. Using a screwdriver, spread the claw of the cable clamp and disconnect the outer cable.

HINT: Tape the screwdriver tip before use.

b. Remove the inner cable from the heater control assembly.




2. REMOVE BLOWER SPEED CONTROL SWITCH
a. Disconnect the connector.
b. Remove the 2 screws.
c. Remove the switch.




3. REMOVE DEF. MODE SWITCH
Release the 2 claws, then remove the switch.

HINT: Tape the screwdriver tip before use.

REASSEMBLY




1. INSTALL DEF. MODE SWITCH
Install the switch.

HINT: After installation, check the fitting 2 claws.




2. INSTALL BLOWER SPEED CONTROL SWITCH
a. Install the switch with the 2 screws.
b. Connect the connector.

3. INSTALL HEATER CONTROL CABLES
Install the heater control cables to the heater control assembly.



pro multis · About Operation CHARM