Transmission Position Sensor/Switch: Service and Repair

ON-VEHICLE REPAIR





1. DISCONNECT OIL COOLER PIPE
2. REMOVE PARK/NEUTRAL POSITION SWITCH
a. Disconnect the connector.
b. Pry off the lock washer and remove the nut.
c. Remove the bolt and park/neutral position switch.
3. INSTALL PARK/NEUTRAL POSITION SWITCH
a. Install the park/neutral position switch and bolt.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
b. Install a new lock plate and the nut.
Torque: 3.9 Nm (40 kgf-cm, 35 inch lbs.)
c. Bend claws on the lock plate to fix the nut.
d. Connect the connector.
e. Check that the engine can be started with the shift lever only in the N or P position, but not in other positions.
If not as stated above, carry out the adjustment procedure. Description of On-Board Diagnostics


4. CONNECT OIL COOLER PIPE
5. FILL ATF AND CHECK FLUID LEVEL
6. TEST DRIVE VEHICLE