Flex Plate
DRIVE PLATE AND RING GEAR SUB-ASSEMBLYInstall and uniformly tighten 10 new bolts in the sequence shown in the illustration.
Torque 30 Nm (301 kgf-cm, 22 ft-lbf)
Do not reuse the flywheel installation bolts.
Do not strike or damage the flywheel installation bolts. Be sure to handle them carefully.
Mark the upside of each flywheel installation bolt with paint.
Tighten the flywheel installation bolts 90° as shown in the illustration.
Check that the painted marks are now at a 90° angle to the upside.