Pattern Select Switch Power Mode Circuit

HYBRID / BATTERY CONTROL: HYBRID CONTROL SYSTEM: Pattern Select Switch Power Mode Circuit
- Pattern Select Switch Power Mode Circuit

DESCRIPTION

When selecting power mode, the switch operation signal is sent to the ECM. Following this, the drive torque is optimally controlled to obtain a sporty feel in response to the driver's acceleration operation.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING TECHSTREAM (CAN BUS CHECK) EV Drive Mode Switch Circuit

B -- GO TO CAN COMMUNICATION SYSTEM CAN Communication System
A -- Continue to next step.

2. CHECK DTC OUTPUT (ALL) EV Drive Mode Switch Circuit

B -- GO TO DTC CHART
A -- Continue to next step.

3. PERFORM ACTIVE TEST USING TECHSTREAM (COMBINATION METER)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Enter the following menus: Body Electrical / Combination Meter / Active Test / Indicat. Lamp ECT PWR.

(d) Perform the "Indicat. Lamp ECT PWR" Active Test.

OK





Result:





B -- REPLACE COMBINATION METER ASSEMBLY Components
A -- Continue to next step.

4. READ VALUE USING TECHSTREAM (PATTERN SWITCH (PWR/M))

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Enter the following menus: Powertrain / Hybrid Control / Data List / Pattern Switch (PWR/M).

(d) Read the value displayed on the Techstream.





Result:





B -- CHECK PATTERN SELECT SWITCH (POWER MODE SWITCH)

A -- CHECK FOR INTERMITTENT PROBLEMS Check For Intermittent Problems

5. CHECK PATTERN SELECT SWITCH (POWER MODE SWITCH)

(a) Remove the pattern select switch (POWER mode switch).





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





(c) Install the pattern select switch.

NG -- REPLACE PATTERN SELECT SWITCH
OK -- Continue to next step.

6. CHECK HARNESS AND CONNECTOR (POWER MODE SWITCH - BODY GROUND)

(a) Disconnect connector L78 from the pattern select switch (POWER mode switch).





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





(c) Connect the pattern select switch connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

7. CHECK HARNESS AND CONNECTOR (PATTERN SELECT SWITCH (POWER MODE SWITCH) - ECM)

(a) Disconnect connector L78 from the pattern select switch.

(b) Disconnect connector A57 from the ECM.

(c) Measure the resistance according to the value(s) in the table below.





Standard Resistance:





Text in Illustration





(d) Connect the ECM connector.

(e) Connect the pattern select switch connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE ECM Components