Installation

SUPPLEMENTAL RESTRAINT SYSTEM: SEAT POSITION SENSOR: INSTALLATION

CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it Service Precautions.

1. INSTALL SEAT POSITION AIRBAG SENSOR

(a) Using a 1 mm (0.039 in.) feeler gauge, install the seat position sensor.

NOTICE:
* If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
* When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
HINT
Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm to 1.4 mm (0.023 to 0.055 in.).

(b) Using a T30 "torx" socket, tighten the "torx" screw to install the seat position sensor.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(c) Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm to 1.4 mm (0.023 to 0.055 in.).

(d) Connect the connector.

(e) Install the seat slide position sensor protector to the seat position sensor.





2. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat) Installation

3. INSTALL FRONT SEAT ASSEMBLY (for Power Seat) Installation

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Problem Symptoms Table.