Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR: INSTALLATION

1. INSTALL SEAT POSITION AIRBAG SENSOR

(a) Install the seat position airbag sensor to the seat slide position sensor protector with the pin as shown in the illustration.





(b) Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position airbag sensor.





Text in Illustration





NOTICE:
* If the seat position airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position airbag sensor with a new one.
* When installing the seat position airbag sensor, be careful that the SRS wiring does not interfere with or is pinched between other parts.

HINT
Be sure that the clearance between the seat position airbag sensor and seat rail is between 0.6 mm (0.0236 in.) and 2.0 mm (0.0787 in.).

(c) Using a T30 "TORX" socket wrench, tighten the "TORX" screw to install the seat position airbag sensor.





Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(d) Make sure that the clearance between the seat position airbag sensor and seat rail is between 0.6 mm (0.0236 in.) and 2.0 mm (0.0787 in.).

(e) Install the wire harness to the seat slide position sensor protector.

(f) Connect the connector.

(g) Check that there is no looseness in the installation parts of the seat position airbag sensor.

2. INSTALL FRONT SEAT CUSHION SHIELD LH Reassembly

3. INSTALL VERTICAL ADJUSTING HANDLE LH (w/ Vertical Adjuster) Reassembly

4. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH Reassembly

5. INSTALL FRONT SEAT ASSEMBLY LH

Installation

6. PERFORM DIAGNOSTIC SYSTEM CHECK

Reading and Clearing Diagnostic Trouble Codes