Multi-Pin Plug Behind Relay Plate, Removing and Installing

NOTE: Multi-pin connector pin assignment, see Electrical Wiring Diagrams.

Multi-Pin Plug, Removing:




- Pull the retaining slide -1-, on rear of relay plate, out of housing -arrow- as far as possible (about 5 mm, (0.2 in.)).




- Press retaining lug on multi-pin connector -arrow- and pull out of relay plate.

Installing:

NOTE: Insert connector so that locking pin -2- faces toward locking slide -1-.

- Push multi-pin connector into appropriate location to stop with locking pin -2- located in recess -4- until retaining tab -3- engages.
- Push locking slide -1- against stop -arrow-; only possible when all multi-pin connectors are pushed in to retaining tab -3- engagement.