Procedures

Power Window Regulators, Checking Position

• After disconnecting and reconnecting the battery, the run-up and run-down function of the power window regulators will not function. Before delivering a new vehicle, the window regulator must be repositioned. The vehicle battery must not be disconnected after the electric windows have been positioned.

CAUTION!
After disconnecting and reconnecting the battery, pinch protection of the power window regulators will not function. This can cause serious injuries if e.g. fingers are caught in the window!

Perform the following work sequence to position the electric windows:

• The following work sequence is for the front left window. The positioning for the remaining windows is performed in the same manner using the respective switch in the driver's door.

- Switch ignition on.

- Close all doors and windows completely.

- Hold left front side-window in position "Close" by pulling and holding switch for longer than 1 second.

- Lift button again for 1 second. Now when the button is pressed briefly the window will lower fully and when the button is lifted briefly the window will raise fully.

- Switch off ignition