Selection of Control Module Sensor When Programming Speed Sig.

Selection Of Control Module Sensor Version When Programming The Speed Signal







NOTE: The speed signal cannot be programmed on certain older control module variants. The P/N of the control module must be read off to identify the control module version.


- Ignition on
- Read off the P/N of the ECC control module. Compare it with the P/N below.

The type of speed signal cannot be programmed on the following control modules (P/N):
- 9134783
- 9134784
- 9171404
- 9171405
- 9171551
- 9171552
- 9171594
- 9171595
- 9459455
- 9459456.

Is the control module PIN different from the above list?

Yes - Programming the Speed Signal, ECC

No - Information