Signal Too High/Signal Too Low. Permanent Fault

Signal too high/signal too low. Permanent fault

Replacing component




- Ignition off.
The control module has registered an internal fault. Try a new control module according to Replacing the engine control module (ECM) Service and Repair.

Note! When replacing a control module the new software must be programmed into the control module.






Continue - Fault-tracing information
FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Replacing component

-------------------------------------------------