Internal Fault. Permanent Fault

Internal fault. Permanent fault

Checking shift solenoids S1 and S2




- Ignition on.
- Gear selector in position P.
- Activate solenoid S1 and S2 individually.
The values should change between OFF and ON.





Do the values alternate between OFF/ON?

Yes - Exit fault-tracing

No - Replacing control module and programming

-------------------------------------------------

Replacing control module and programming

Caution! A new control module is delivered without software. The control module must be programmed in order to function after replacement.

For further information about programming and replacing the control module, see Replacing the gearbox control module (TCM) .





Continue - Verification

-------------------------------------------------

Verification




Verification




- Ignition on.
- Gear selector in position P.
- Activate solenoid S1 and S2 individually.
The values should change between OFF and ON.





Do the values alternate between OFF/ON?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking shift solenoids S1 and S2

-------------------------------------------------