Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Thermostat, Checking/Replacing




THERMOSTAT, CHECKING/REPLACING

Note! Drain approximately. 2 liters (0.53 US gallons) of coolant. Remove expansion tank cap. Open nipples on the left side of underside of the radiator, use a hose to lead off coolant. Close the nipple.




Replacing thermostat
Removing/installing thermostat
Remove the hose on the thermostat housing cover and remove the thermostat and gasket (Torx 40).
Clean the mating surface of the thermostat housing.
Install a new seal on the thermostat.
Install the thermostat in the housing, install and tighten the cover and hose.
Fill with coolant and run engine until the thermostat opens and top up as necessary.
Check for leaks.





Check thermostat
Checking opening function
The thermostat can be tested in warm water.
Maximum opening should take place within 2 minutes in water at opening temperature.
Marking:87
Begins to open at:87°C (188°F)
Fully open at:102°C (215.6°F)
Marking:90
Begins to open at: 90°C (194°F)
Fully open at:105°C (221°F)