Bucket Seat Replacement

Bucket Seat Replacement

Removal Procedure

1. Remove the seat belt from the side of the seat belt guide.




2. Remove the nuts that retain the seat to the floor.
3. Disconnect the electrical connector from the power seat if equipped.
4. Remove the seat and the riser from the vehicle.
5. Remove the seat belt guide from the seat riser.




6. Remove the bolts that retain the seat to the riser.
7. Remove the power seat from the seat risers if equipped. Refer to Seat Replacement - Power with Adjuster (Seat Replacement - Power with Adjuster) .
8. Remove the manual seat adjuster wire from the seat tracks .
9. Remove the seat riser spacer nuts and bolts from the seat tracks.
10. Remove the seat riser spacer from the seat risers.



Installation Procedure

1. Install the seat riser spacer to the seat risers.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the seat riser spacer nuts and bolts to the seat tracks.

Tighten the seat riser spacer nuts and bolts to the seat tracks to 30 N.m (22 lb ft).

3. Install the manual seat adjuster wire to the seat tracks.
4. Install the power seat to the seat risers if equipped. Refer to Seat Replacement - Power with Adjuster (Seat Replacement - Power with Adjuster) .
5. Install the seat belt guide to the seat riser.




6. Install the nuts that retain the seat to the risers.

Tighten the nuts that retain the seat to the riser to 43 N.m (32 lb ft).

7. Install the seat and the seat riser in the vehicle.
8. Connect the electrical connector to the power seat if equipped.




9. Install the nuts that retain the seat to the floor.

Tighten the nuts that retain the seat to the floor to 43 N.m (32 lb ft).

10. Install the seat belt to the side of the seat belt guide.