Removal

NAVIGATION / MULTI INFO DISPLAY: NAVIGATION RECEIVER: REMOVAL

1. PRECAUTION

NOTICE:
* After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Service Precautions.
* A Hard Disk Drive (HDD) is built into the navigation receiver assembly to store map and other data, and is used for the navigation system. Therefore, care must be taken when handling the navigation receiver assembly.
* When removing the hard disc drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE REAR CONSOLE BOX ASSEMBLY

Removal

4. REMOVE BOX BOTTOM MAT Removal

5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Removal

7. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

8. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY

(a) Apply protective tape to the area shown in the illustration.





Text in Illustration





(b) Remove the 4 bolts.





(c) Pull the navigation receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 8 clips.





(d) Disconnect each connector and remove the navigation receiver assembly with air conditioning control assembly.

9. REMOVE NO. 1 RADIO RECEIVER BRACKET

(a) Remove the 5 screws and No. 1 radio receiver bracket.





10. REMOVE NO. 2 RADIO RECEIVER BRACKET

(a) Remove the 5 screws and No. 2 radio receiver bracket.





11. REMOVE HARD DISK DRIVE Removal

12. REMOVE AIR CONDITIONING CONTROL ASSEMBLY Removal

13. REMOVE NAVIGATION COMPUTER SUB-ASSEMBLY