Removal

NAVIGATION / MULTI INFO DISPLAY: HARD DISK DRIVE: REMOVAL

1. PRECAUTION

NOTICE:
* After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Service Precautions.
* for Navigation Receiver Type:
* A Hard Disk Drive (HDD) is built into the navigation receiver assembly to store map and other data, and is used for the navigation system. Therefore, care must be taken for the following points when handling the navigation receiver assembly.
* for Radio and Display Type with Intuitive Parking Assist System:
* A Hard Disk Drive (HDD) is built into the radio and display receiver assembly to store multi-media data, and is used for the audio and visual system. Therefore, care must be taken for the following points when handling the radio and display receiver assembly.
* When removing the hard disc drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE REAR CONSOLE BOX ASSEMBLY

Removal

4. REMOVE BOX BOTTOM MAT Removal

5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Removal

7. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

8. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for Navigation Receiver Type) Removal

9. REMOVE RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for Radio and Display Type with Intuitive Parking Assist System) Removal

10. REMOVE NO. 2 RADIO RECEIVER BRACKET (for Navigation Receiver Type) Removal

11. REMOVE NO. 2 RADIO RECEIVER BRACKET (for Radio and Display Type with Intuitive Parking Assist System) Removal

12. REMOVE HARD DISK DRIVE

(a) Remove the 2 screws.





(b) Disengage the 2 guides to remove the cover.

(c) Pull out the hard disk drive from the navigation receiver assembly or radio and display receiver assembly in the direction shown by the arrow in the illustration to remove it.